If you use SLAVE, you shouldn't set POLLED, and you shouldn't use ACKMODE on either end. Enter VFO mode on Band A by pressing VFO. Press TNC until you see PACKET12 in the Band A display. To activate the internal TNC, press the Band A Band Select Knob to make Band A active. SLAVE allows a PC to be multidropped along with one or more KISS TNCs on a multidropped link. COM port settings of the D710 may be checked or changed, select AUX and menus 528 and 529 (pre-D710G) or 929 and 930 (D710G). This mode should always be used if the TNC support it. This will improve link performance by avoiding the possibility of a retry being sent before the original frame has even left the TNC. These cause the TNC to send a reply when the frame has been transmitted. It may be used on its own, but should always be used if POLLED mode is selected.ĪCKMODE enables the transmission of 'ACK required' frames. This reduces the risk of data corruption if errors occur on the link from PC to TNCs. This allows several TNCs to share an async port without any risk of collisions.ĬHECKSUM selects a mode where a checksum byte is appended to each data message, and checked by the other end. POLLED selects multi-dropped mode, where the TNC only transmits when requested (Polled) by the PC. These extended KISS options are supported by my BPQKISS EPROM for the TNC2 and clones, the TNCPI and most Kantronics TNCs (where it is called XKISS). The first 3 select my extended KISS mode. KISSOPTIONS=POLLED,CHECKSUM,ACKMODE,SLAVE,D700,PITNC,NOPARAMS,FLDIGI,TRACKER Some configurations need a KISSOPTIONS paramter. Default for UZ7HO is 8100 and Direwolf 8001 Usually this is the same machine as BPQ, so use 127.0.0.1 but can be on another machine IPADDR=127.0.0.1 Address of PC runnning the TNC. These Need IPADDR and TCPPORT parameters: Software Modems, such as DireWolf or UZ7HO Soundmodem, can use KISS over TCP. Serial ports need COMPORT and SPEED parameters: KISS can operate over a serial port, i2c, TCP and UDP.Īll KISS ports have a number of statements in common: Introduction.Īlthough the basic KISS configuration is simple, with a number of parameters set to reasonable defaults, the KISS driver has a large number of options. BPQ Home BPQ32 Home KISS support in BPQ32/LinBPQ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |